Forums DADman DADman Control Software EQ turns off Left channel.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #2099
    Rich EvansRich Evans

      When I turn on the EQ in DADman Monitor Profile section it turns the Left channel off.

      The dark blue dot turns to light blue and no signal is passed through.

      Turning off the EQ reverts back to normal.

      I’ve included a Screenshot for clarity.

      Any ideas why it is doing this?

      Also, adding a delay to each individual output, turns it off.

      I’m running OSX 10.15.7, Dadman V5.6.5.1 and Firmware

      NTP/DAD SupportNTP/DAD Support

        Firmware version does not exist in a DAD product, so I assume it refers to an Avid MTRX Studio in which case you should contact Avid for further support.

        This behaviour typically happens when the samplerate of the source does not match the samplerate of the box, or when th esource is not synchronised to the box. You can check the samplerate of the source in the routing matrix when you expand it to a channel view. The channel view will the samplerate of the incoming signal to the left (you may have to scroll down a bit). Also make sure there is a green circle next to the source and not a yellow or red triangle.


      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.