Forums › DADman › DADman Control Software › Thundercore Driver – Sample Rate Lock

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 9 April 2026 at 9:02 AM #3086
    Neil ParfittNeil Parfitt
    Participant

      Heya!

      I can’t figure out why this happens – but every so often, MacOS will change the samplerate in Thundercore with general system sound/core audio playback to 44.1

      My MTRX studio is hard set to internal 48K, so when this happens, audio from thunderbolt source will show in DADman, but i wont hear it until i re-open the DAD Driver Setup and flip the rate back to 48K.

      It would be amazing if there was a ‘lock’ checkbox in the DAD Driver Setup – so MacOS can’t override what I set this to.

      Or, is there a pref file I could set to read-only so it can’t change?

      Cheers,

      Neil

      9 April 2026 at 10:25 AM #3089
      Jon SchumannJon Schumann
      Participant

        Hey Neil,

        In the Sync Tab what is the “Adapt to” set to ?

        9 April 2026 at 7:44 PM #3090
        Neil ParfittNeil Parfitt
        Participant

          “Internal”.

          The MTRX is the primary 48K clock of the studio – for ProTools, DANTE, all the things.

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.